宏小區的下行鏈路干擾翻譯-中英對照
測試編號 INTERFERENCE _7
測試項目 Femto小區對宏小區的下行鏈路干擾
測試目的 在異載頻情況下，  測試Femto對宏小區的干擾
測試場景 如圖 9-1 所示
測試設備 1. 路測軟件，如WiNOM RNT現場路測軟件（WCDMA版）
2 若干WCDMA測試終端
測試條件 1. Femto小區工作正常
2. 在異載頻下，宏小區工作正常 在被Femto小區和宏小區共同覆蓋的區域中，選擇一個測試路線。在測試 路線上的所有點上都能夠檢測到Femto小區和宏小區的導頻信號。
測試過程 1. 測量Femto小區和宏小區的導頻Ec/Io。在測試路線的任何點上，記錄
它。
2. 這些UE將注冊到宏小區上，記錄UE的接收功率、RSCP、BLER
3. 在無負載下監測TCP，記錄它
4. 通過2個移動終端請求PS384業務來增加Femto小區的下行鏈路負荷。
重復步驟1－2，并且記錄TCP值
測試記錄 1. Femto小區和宏小區的導頻Ec/Io
2. UE的接收功率、RSCP、BLER
3. TCP值
備注 
測試結果 □  通過
□  未通過
9.8.2.4 INTERFERENCE _8:  宏小區對 Femto 小區的下行鏈路干擾
測試編號 INTERFERENCE _8
測試項目 宏小區對Femto小區的下行鏈路干擾
測試目的 在異載頻情況下，測試宏小區對Femto的干擾
測試場景 如圖 9-1 所示
第 108 頁
測試設備 1. 路測軟件，如WiNOM RNT現場路測軟件（WCDMA版）
2. 若干WCDMA測試終端
測試條件 1. Femto小區工作正常
2. 在異載頻下，宏小區工作正常 在被Femto小區和宏小區共同覆蓋的區域中，選擇一個測試路線。在測試 路線上的所有點上都能夠檢測到Femto小區和宏小區的導頻信號。測試過程 1. 測量Femto小區和宏小區的導頻Ec/Io。在測試路線的任何點上，記錄
它。
2. 這些UE將注冊到Femto小區上，記錄UE的接收功率、RSCP、BLER

3. 無負載下監測TCP，記錄它
4. 增加宏小區的下行鏈路負荷到50％（通過增加PICH功率偏移）。重
復步驟1－2，并且記錄TCP值
測試記錄 1. Femto小區和宏小區的導頻Ec/Io
2. UE的接收功率、RSCP、BLER
3. TCP值
備注 
測試結果 □  通過□  未通過
9.9 多個 Femto 小區間干擾測試8
在 2 個 Femto 小區覆蓋的區域內進行測試，如圖 9-2 所示。
Femto cell1 Femto cell2
圖 9-2 2 個 Femto 小區覆蓋的區域內進行測試的情況
9.1 同載頻情況下的干擾測試
9.9.1.1 INTERFERENCE _9: Femto 小區 2 對 Femto 小區 1 的上行鏈路干擾
測試編號 INTERFERENCE _9
測試項目 Femto小區2對Femto小區1的上行鏈路干擾
測試目的 在同載頻情況下，測試Femto小區2對Femto1的干擾
測試場景 如圖 9-2 所示
8   由于實驗環境問題，該部分建議到外場環境下測試。
測試設備 1. 路測軟件，如WiNOM RNT現場路測軟件（WCDMA版）
2. 若干WCDMA測試終端
測試條件 1. Femto小區1和Femto小區2都正常工作且工作在同頻載波上
2. 在Femto小區1和Femto小區2之間的區域中，選擇2個不同點作為測試 點。在一個點上，來自Femto  小區2的信號好。另一個點上，來自Femto 小區2的信號差。
測試過程 1. 關閉Femto小區2，記錄Femto小區1的RSSI
2. 打開Femto小區2，但是UE不注冊，記錄Femto小區1和Femto小區2的
RSSI

3. 在測試點1，這些UE注冊到Femto小區2，記錄UE的發射功率、Femto
小區1和Femto小區2的RSSI。保持這個過程5分鐘。
4. 在測試點2，這些UE注冊到Femto小區2，記錄UE的發射功率、Femto
小區1和Femto小區2的RSSI。保持這個過程5分鐘。

測試記錄 1. Femto小區1和Femto小區2的RSSI
2. UE的發射功率
備注 
測試結果 □  通過
□  未通過
9.9.1.2 INTERFERENCE _10: Femto 小區 2 對 Femto 小區 1 的下行
鏈路干擾
測試編號 INTERFERENCE _10
測試項目 Femto小區2對Femto小區1的下行鏈路干擾
測試目的 在同載頻情況下，  Femto小區2對Femto小區1的干擾
測試場景 如圖 9-2 所示
測試設備 1. 路測軟件，如WiNOM RNT現場路測軟件（WCDMA版）
2. 若干WCDMA測試終端
測試條件 1. Femto小區1和Femto小區2都正常工作且工作在同頻載波上
2. 在被Femto小區1和Femto小區覆蓋的區域中，選擇一個測試路線。在 測試路線上的所有點上都能夠檢測到Femto小區1和Femto小區2的導 頻信號。
9.8.1.4 INTERFERENCE _ 4:  The down chain to Femto district of great district is interfered
Test number  INTERFERENCE _ 4
Test item  The down chain to Femto district of great district is interfered
Test objective  In with carrier frequency cases , test the interference to Femto of great district
Test the scene  Such as pursueing  9-1 Show
Test the equipment  1. The way examines the software, the way examines the software (WCDMA edition ) live such as WiNOM RNT
2. Several WCDMA tests the terminal station
Test the condition  1.Femto district operates normally
2. With carrier frequency, operate normally in the area that is covered together by Femto district and great district in the great district, choose a test route. The ones that have and can be measured to Femto district and great district at all o'clock in testing the route lead the signal frequently .
Test procedure  
2. Several WCDMA tests the terminal station
Test the condition  1.Femto district operates normally
2. Under different carrier frequency, operate normally in the area that is covered together by Femto district and great district in the great district, choose a test route. The ones that have and can be measured to Femto district and great district at all o'clock in testing the route lead the signal frequently .
Test procedure  1. The ones that measure Femto district and great district lead Ec/Io frequently . In any of testing the route is clicked, the record
It.
2. These UEs will register to the great district , will write down receiving power , RSCP , BLER of UE
3. Monitor TCP , record it under having load
4. Increase the down chain load of Femto district through 2 portable terminal request PS384 business.
Repeat the step 1-, and write down TCP value
Test the record  1.Director in Femto district and great district Ec/Io frequently
2.Receiving power , RSCP , BLER of UE
3.TCP value
Note  
Test result  □  Pass
□  Fail
9.8.2.4 INTERFERENCE _ 8:  The down chain to Femto district of great district is interfered
Test number  INTERFERENCE _ 8
Test item  The down chain to Femto district of great district is interfered
Test objective  In case of different carrier frequency , test the interference to Femto of great district
Test the scene  Such as pursueing  9-1 Show
Test the equipment  1. The way examines the software, the way examines the software (WCDMA edition ) live such as WiNOM RNT
2. Several WCDMA tests the terminal station
Test the condition  1.Femto district operates normally
2. Under different carrier frequency, operate normally in the area that is covered together by Femto district and great district in the great district, choose a test route. The ones that have and can be measured to Femto district and great district at all o'clock in testing the route lead the signal frequently .
Test procedure  1. The ones that measure Femto district and great district lead Ec/Io frequently . In any of testing the route is clicked, the record
It.
2. These UEs will register to Femto district , will write down receiving power , RSCP , BLER of UE
3. Have load monitor TCP , record it
4. The down chain load which increases the great district reaches 50% (pass and increase PICH power skew). Heavy
Reply the step 1-, and write down TCP value
Test the record  1.Director in Femto district and great district Ec/Io frequently
2.Receiving power , RSCP , BLER of UE
3.TCP value
Note  
Test result  □  Pass
□  Fail
9.9 The small block of a lot of Femto interferes testing 8
Test in the area covered in 2 Femto district, as Fig. 9-2 shows.
Femto cell1 Femto cell2
Situation tested in the area covered in 9-2 2 Femto district of Fig.
9.9.1 Test with the interference under the carrier frequency situation
9.9.1.1 INTERFERENCE _ 9: Femto district  2 pairs of up chains of 1 in Femto district
The way interfering
Test number  INTERFERENCE _ 9
Test item  2 up chains to 1 in Femto district of Femto district are interfered
Test objective  In with carrier frequency cases , test the interference of Femto district 2 pairs of Femto1
Test the scene  Such as pursueing  9-2 Show
8 should propose testing under the outfield environment partly because of the environmental question of the experiment .
Test the equipment  1. The way examines the software, the way examines the software (WCDMA edition ) live such as WiNOM RNT
2. Several WCDMA tests the terminal station
Test the condition  1.Work and not work Femto district the 1 and Femto district 2 normally in and at signal carrier frequently
2. In the area between Femto district 1 and Femto district 2 , choose 2 pieces of difference conduct to test and click. Get on a point, the signal of 2 is good that come from Femto district. In another point, the signal of 2 is bad that come from Femto district.
Test procedure  1. Close Femto district 2, write down RSSI of 1 in Femto district
2. Open Femto in district 2, but UE is not registered , ones that write down 2 for 1 in Femto district and Femto district
RSSI
3. Testing and ordering 1, these UE is being registered to 2, writes down the power of transmission , Femto of UE
RSSI of 2 districts 1 and Femto districts. Keep for 5 minutes of this course.
4. Testing and ordering 2, these UE is being registered to 2, writes down the power of transmission , Femto of UE
RSSI of 2 districts 1 and Femto districts. Keep for 5 minutes of this course.
Test the record  1.RSSI of 2 for 1 in Femto district and Femto district
2.Power of transmission of UE
Note  
Test result  □  Pass
□  Fail
9.9.1.2 INTERFERENCE _ 10: Femto district  1 in Femto district of 2 pairs is down
The chain interfering
Test number  INTERFERENCE _ 10
Test item  2 down chains to 1 in Femto district of Femto district are interfered
Test objective  In case of and carrier frequency, 2 pairs of interference of 1 in Femto district of Femto district
Test the scene  Such as pursueing  9-2 Show
Test the equipment  1. The way examines the software, the way examines the software (WCDMA edition ) live such as WiNOM RNT
2. Several WCDMA tests the terminal station
Test the condition  1.Work and not work Femto district the 1 and Femto 2 of districts normally in and at signal carrier frequently
2. In the area that is covered by Femto district 1 and Femto district , choose a test route. The ones that have and can be measured to 2 for 1 in Femto district and Femto district at all o'clock in testing the route lead the signal frequently .

2013.1.23